W
William Sommerwerck
Guest
Since I posted my original question about the failure of my JVC hall
synthesizer...
Several years ago, when I turned it on after a long period of disuse, the
VF
display was scrambled and the unit didn't work. I let it "cook" for a
day,
and the (apparently) malformed cap that was causing the problem decided
to
behave itself.
Several weeks ago, I finally got my rear amplifiers, so the JVC was
restored
to full-time service, and was working magnificently, until... You guessed
it.
About a half-hour ago, the display went dead and the outputs turned into
a
not-too-loud digital "buzz". The input is locked at "digital". (The
default
is analog, and you have to manually switch.)
My guess -- and this is only a guess -- is that this a power supply
problem.
(The fact that all the channels went out does not automatically eliminate
any of the LSIs, unfortunately.) I have the service manual, but before I
start ordering mass quantities of electronics (or even start checking
voltages), I'd like to know if anyone has any views.
Please note that I don't expect anyone to diagnose what might be a messy
problem from a distance. (I'll call JVC tomorrow, anyway.) I just wanted
opinions.
....I've done some more checking. I found that if I let the unit sit
overnight, it comes on again -- then fails after a few minutes. I've been
able to repeat this.
This suggests some component is failing then reviving. (Duh...) As the
symptoms -- dead display, input locked to digital source, low-level buzz at
all outputs -- are not likely to be caused by the failure of a single chip,
the likelihood of something in the power supply -- in this case a bad cap
that "comes and goes" -- seems likely.
Any thoughts?
Thank you.
synthesizer...
Several years ago, when I turned it on after a long period of disuse, the
VF
display was scrambled and the unit didn't work. I let it "cook" for a
day,
and the (apparently) malformed cap that was causing the problem decided
to
behave itself.
Several weeks ago, I finally got my rear amplifiers, so the JVC was
restored
to full-time service, and was working magnificently, until... You guessed
it.
About a half-hour ago, the display went dead and the outputs turned into
a
not-too-loud digital "buzz". The input is locked at "digital". (The
default
is analog, and you have to manually switch.)
My guess -- and this is only a guess -- is that this a power supply
problem.
(The fact that all the channels went out does not automatically eliminate
any of the LSIs, unfortunately.) I have the service manual, but before I
start ordering mass quantities of electronics (or even start checking
voltages), I'd like to know if anyone has any views.
Please note that I don't expect anyone to diagnose what might be a messy
problem from a distance. (I'll call JVC tomorrow, anyway.) I just wanted
opinions.
....I've done some more checking. I found that if I let the unit sit
overnight, it comes on again -- then fails after a few minutes. I've been
able to repeat this.
This suggests some component is failing then reviving. (Duh...) As the
symptoms -- dead display, input locked to digital source, low-level buzz at
all outputs -- are not likely to be caused by the failure of a single chip,
the likelihood of something in the power supply -- in this case a bad cap
that "comes and goes" -- seems likely.
Any thoughts?
Thank you.