L
Lenny
Guest
The customer was complaining that the set would shut off after being
on for varying amounts of time. If he waited about a half hour he
would be able to turn it back on again.
The first thing I did before I even attempted to power it up was to go
over all suspicious soldering. I then powered it up and it ran for
about 30 minutes before it shut itself off. I felt the heat sinks,
flyback and the electrolytics on the board and nothing seemed to have
been running especially hot. I have had it off for almost an hour and
now all it does is click. I don't think its related to anything I
resoldered but I'm just wondering if anyone might have a clue as to
what the original problem may have been and if perhaps its related to
this new one. Or maybe I now have two problems? I have no schematic
so thanks for any assistance. Lenny Stein, Barlen Electronics
on for varying amounts of time. If he waited about a half hour he
would be able to turn it back on again.
The first thing I did before I even attempted to power it up was to go
over all suspicious soldering. I then powered it up and it ran for
about 30 minutes before it shut itself off. I felt the heat sinks,
flyback and the electrolytics on the board and nothing seemed to have
been running especially hot. I have had it off for almost an hour and
now all it does is click. I don't think its related to anything I
resoldered but I'm just wondering if anyone might have a clue as to
what the original problem may have been and if perhaps its related to
this new one. Or maybe I now have two problems? I have no schematic
so thanks for any assistance. Lenny Stein, Barlen Electronics