I use CADStar 9, in fact we just bought it in December.
I have never used Protel, but I did try a trial version back a few years
ago (OK maybe more than a few) when we were looking to change from our
old protected mode DOS system. I didn't like the UI. I went with PCAD
and stuck with them until this last fiasco with Altium.
CADStar took a little getting use to after 6 years of using PCAD, but I
am liking it more and more.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
