Zenith SR2568S Help Needed!

[NPNTEK]

Hello Group:

Subject: Zenith SR2568S 27" TV

This set had two (2) initial problems ... not sure if they are related:

1. Loss of Green Color ... I was able to repair this problem by resoldering
some cold solder joints on CRT board.

2. If I turn the set to a channel above 39 (CH 42 for example), I can see the
channel and everything "seems" ok however, if I turn the power OFF - Then back
ON, the same channel will be selected however, all I see is "snow" (blank
raster). If I flip down to a lower channel (CH 3 for example), then go back to
CH 42, it works (can see the broadcast)

I noticed that when I set up the Channels (via auto channel routine from the
menu) the channels that cause trouble (e.g., CH 42) are not "found" during the
auto channel search.

I would really appreciate any repair info that you folks can offer!!

Regards,

RJ

 

[Jerry G.]

Check to see if the voltages to the tuner are correct. It is possible that
the tuner module is defective, and would require replacement.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
=========================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
=========================================


"NPNTEK" <npntek@aol.comremove> wrote in message
news:20031031060002.03666.00000065@mb-m06.aol.com...
Hello Group:

Subject: Zenith SR2568S 27" TV

This set had two (2) initial problems ... not sure if they are related:

1. Loss of Green Color ... I was able to repair this problem by resoldering
some cold solder joints on CRT board.

2. If I turn the set to a channel above 39 (CH 42 for example), I can see
the
channel and everything "seems" ok however, if I turn the power OFF - Then
back
ON, the same channel will be selected however, all I see is "snow" (blank
raster). If I flip down to a lower channel (CH 3 for example), then go back
to
CH 42, it works (can see the broadcast)

I noticed that when I set up the Channels (via auto channel routine from the
menu) the channels that cause trouble (e.g., CH 42) are not "found" during
the
auto channel search.

I would really appreciate any repair info that you folks can offer!!

Regards,

RJ