A
Antti Lukats
Guest
Hi
just got XCF02S and XCF04S soldered in and it instantly worked, well
I did choose erase first in iMpact and then it was frozen for 10 seconds
during erase time (I was already afraid something is not OK) but after
programming the FPGA board did come alive, first time without jtag
cable attached, and said hello from MicroBlaze program.
XCF0xS devices are really nice, the package is smaller then SO14, smaller
than DIP8 and only slightly bigger than SO8, and they are very low priced
(below 7EUR)
so if somebody has to choose xilinx config memory then Platform Flash
is defenetly there and available!
antti
http://www.graphord.com/forum
just got XCF02S and XCF04S soldered in and it instantly worked, well
I did choose erase first in iMpact and then it was frozen for 10 seconds
during erase time (I was already afraid something is not OK) but after
programming the FPGA board did come alive, first time without jtag
cable attached, and said hello from MicroBlaze program.
XCF0xS devices are really nice, the package is smaller then SO14, smaller
than DIP8 and only slightly bigger than SO8, and they are very low priced
(below 7EUR)
so if somebody has to choose xilinx config memory then Platform Flash
is defenetly there and available!
antti
http://www.graphord.com/forum