Why multiplex signals?

[Neha]

Hi. I'm an undergrad student & we're designing an 8051 core,
for an FPGA.
Most of the cores i saw, have multiplexed the port and ext memory
interface signals, as is the case for an 8051chip.

I want to make separate ports for IO & ext mem, as it will simplify my
design. Please tell me the tradeoffs for this.

In general, why do you need to multiplex signals for a core? finally,
it's going to be used to make some sys. on-a-chip ,right?

(I'm a beginner at digital design)

Thanks.
Neha

 

[filmil]

On Mar 23, 3:22 pm, "Neha" <neha.karanj...@gmail.com> wrote:

In general, why do you need to multiplex signals for a core? finally,
it's going to be used to make some sys. on-a-chip ,right?

The historic reason for using multiplexed buses was to have as few as
possible pins on the chip's package. The fewer the pins, the cheaper
the device.

If you design for system on a chip, there is no special need to
multiplex anything, as long as your wiring does not get insanely
complex so that you don't run out of resources, and you don't use up
pins on the FPGA, if you need to lead your processor's pins outside
the FPGA.

Modern FPGAs can have lots of pins you can use, so you should have no
problems with demultiplexing buses for a small 8bit design like 8051,
but it is best to check your FPGA and board manuals to be sure.

f

 

[Jim Granville]

Neha wrote:

Hi. I'm an undergrad student & we're designing an 8051 core,
for an FPGA.
Most of the cores i saw, have multiplexed the port and ext memory
interface signals, as is the case for an 8051chip.

I want to make separate ports for IO & ext mem, as it will simplify my
design. Please tell me the tradeoffs for this.

In general, why do you need to multiplex signals for a core? finally,
it's going to be used to make some sys. on-a-chip ,right?

They do that to 'match' the original cores operation, so it can
drop-into as many designs as possible.

Two things are multiplexed :

a) P2 shares with A8-A15, and that
can matter if your code uses PDATA [MOVX @ Ri opcodes ]
If you never use PDATA, you can move P2 to other pins.

b) A0-A7 shares with DB0-DB7 - there is no SW impact of
this, but some peripheral devices have ALE pins, and so
expect the sharing, and will not work with non-mux bus.
If you never use ALE peripherals, then you are probably OK
to move A0-A7 to other pins.

-jg

 

[Neha]

Thanks