What do you use to supply air to your hot-air desoldering st

[mike]

I bought a Leister Labor S7B hot air system.
Unfortunately, it's minus the air.
Air has to get thru 10 feet of hose with a wire
running down the center.
I need about 10 CFM at 10PSI give or take.
3/4HP air compressor running wide open can just keep up.
And I don't want to have to go to the garage to use it.
Centrifugal blowers that I have can't stand the back pressure.
Need something with lots of volume at low pressure.
Any suggestions for a cheap solution before I start taking apart the
vacuum cleaner?
Thanks, mike
--
Return address is VALID.
Wanted, PCMCIA SCSI Card for HP m820 CDRW.
FS 500MHz Tek DSOscilloscope TDS540 Make Offer
http://nm7u.tripod.com/homepage/te.html
Wanted, 12.1" LCD for Gateway Solo 5300. Samsung LT121SU-121
Bunch of stuff For Sale and Wanted at the link below.
http://www.geocities.com/SiliconValley/Monitor/4710/

 

[John Woodgate]

I read in sci.electronics.design that mike <spamme0@netscape.net> wrote
(in <41FC5EBE.7060506@netscape.net&gt about 'What do you use to supply
air to your hot-air desoldering station?', on Sat, 29 Jan 2005:

Need something with lots of volume at low pressure.
Any suggestions for a cheap solution before I start taking apart the
vacuum cleaner?

To me, 'lots of volume at low pressure' means 'vacuum cleaner'. Buy one
at a garage sale?
--
Regards, John Woodgate, OOO - Own Opinions Only.
The good news is that nothing is compulsory.
The bad news is that everything is prohibited.
http://www.jmwa.demon.co.uk Also see http://www.isce.org.uk