Wavescan: freezing graph problem

[Svetozar Broussev]

Hello,

I'm new in using Wavescan, so this is probably very trivial question, but my
graph updates every time when a simulation finishes. According to the user
guide, when the 'freezing on' button is selected, the graph should remain
unchanged, and the new result can be updated with 'Reload'. Somehow this
doesn't work for me, after the simulation is completed, the outputs are
evaluated, and all the sub-plots are disappearing except the first one,
which of course is very annoying.

I hope there is easy solution for this.

Thanks in advance.

(Wavescan version is 5.10.41.500.3.54, if that's important)

 

[linkin]

An alternative you might want to try:

If you are using Analog Design Environment (ADE) for simulation, try
selecting "New Window" instead of "Replace" using the mini-menu near
the lower-right-hand corner of the ADE window. Then when you rerun the
sim, it should plot the new results in a new window and leave the old
results in the old plot window.



Svetozar Broussev wrote:

Hello,

I'm new in using Wavescan, so this is probably very trivial question, but my
graph updates every time when a simulation finishes. According to the user
guide, when the 'freezing on' button is selected, the graph should remain
unchanged, and the new result can be updated with 'Reload'. Somehow this
doesn't work for me, after the simulation is completed, the outputs are
evaluated, and all the sub-plots are disappearing except the first one,
which of course is very annoying.

I hope there is easy solution for this.

Thanks in advance.

(Wavescan version is 5.10.41.500.3.54, if that's important)

 

[Svetozar Broussev]

Thanks a lot!

The proposed solution works, but you need to have at least one plot defined
as a output. If all the outputs give numerical data, then ADE does not open
a new window, and destroys the main one.

Still, one can always define dummy plot. Probably there is smarter
solution, but this one works too.


"linkin" <liu.anray@gmail.com> wrote in message
news:1163601159.194348.233680@k70g2000cwa.googlegroups.com...

An alternative you might want to try:

If you are using Analog Design Environment (ADE) for simulation, try
selecting "New Window" instead of "Replace" using the mini-menu near
the lower-right-hand corner of the ADE window. Then when you rerun the
sim, it should plot the new results in a new window and leave the old
results in the old plot window.



Svetozar Broussev wrote:
Hello,

I'm new in using Wavescan, so this is probably very trivial question, but
my
graph updates every time when a simulation finishes. According to the
user
guide, when the 'freezing on' button is selected, the graph should
remain
unchanged, and the new result can be updated with 'Reload'. Somehow this
doesn't work for me, after the simulation is completed, the outputs are
evaluated, and all the sub-plots are disappearing except the first one,
which of course is very annoying.

I hope there is easy solution for this.

Thanks in advance.

(Wavescan version is 5.10.41.500.3.54, if that's important)