B
Brad Smallridge
Guest
I have been using CoreGen to generate the DCMs on a Spartan3 project. After
going through the wizzard, I can select the .XCO in the process window, and
can view two files, the HDL Source and the HDL Instantiation Template. I
don't worry about the source file. The template file, I cut, paste, and
fill in the blanks with my signals.
Things went a little different with an Async FIFO generation. When
selecting the fifo.xco source, instead of two files, I can view only one
file, called the Functional Model. What's the difference? I was able, I
think, to figure out the instantiation of this generated device although I
am getting a WARNING:HDLParsers:3481 - No primary, secondary unit in the
file, warning and consequently an excamation point near the check syntex
process in my top design. How do I get rid of this warning, and where, in
general, do I look up HDLParsers warnings/errors?
Brad Smallridge
a i v i s i o n . c o m
going through the wizzard, I can select the .XCO in the process window, and
can view two files, the HDL Source and the HDL Instantiation Template. I
don't worry about the source file. The template file, I cut, paste, and
fill in the blanks with my signals.
Things went a little different with an Async FIFO generation. When
selecting the fifo.xco source, instead of two files, I can view only one
file, called the Functional Model. What's the difference? I was able, I
think, to figure out the instantiation of this generated device although I
am getting a WARNING:HDLParsers:3481 - No primary, secondary unit in the
file, warning and consequently an excamation point near the check syntex
process in my top design. How do I get rid of this warning, and where, in
general, do I look up HDLParsers warnings/errors?
Brad Smallridge
a i v i s i o n . c o m