unkown output impedance measurement?

Dave
I was wrong it's only 10 watts. I know of no reason, perhaps someone
here will tell us. They made tens of thousands of these so it must have
had a need...
"Dave Plowman (News)" <dave@davenoise.co.uk> wrote in message
news:4ffc1003a7dave@davenoise.co.uk...
In article <GAWRk.7851$YU2.6580@nlpi066.nbdc.sbc.com>,
Henry Kolesnik <kolesnik@nojunksbcglobal.net> wrote:
The SP 310X has a pair of 6F6 triode connected driving a pushpull
transformer with output of 15 watts. It was mainly a military Rx BC
794
etc butmine is a civilian model.

I can't see rhyme or reason for such a high power output at that
impedance.

No cathode follower.
Any headphones work fine at 10 ohms.

If 10 ohm headphones work fine I doubt the output is 600 ohms.

--
*Filthy stinking rich -- well, two out of three ain't bad

Dave Plowman dave@davenoise.co.uk London SW
To e-mail, change noise into sound.
 
In article <GAWRk.7851$YU2.6580@nlpi066.nbdc.sbc.com>,
Henry Kolesnik <kolesnik@nojunksbcglobal.net> wrote:
The SP 310X has a pair of 6F6 triode connected driving a pushpull
transformer with output of 15 watts. It was mainly a military Rx BC 794
etc butmine is a civilian model.
I can't see rhyme or reason for such a high power output at that impedance.

No cathode follower.
Any headphones work fine at 10 ohms.
If 10 ohm headphones work fine I doubt the output is 600 ohms.

--
*Filthy stinking rich -- well, two out of three ain't bad

Dave Plowman dave@davenoise.co.uk London SW
To e-mail, change noise into sound.
 
In article <NzXRk.7853$YU2.4393@nlpi066.nbdc.sbc.com>,
Henry Kolesnik <kolesnik@nojunksbcglobal.net> wrote:
I was wrong it's only 10 watts. I know of no reason, perhaps someone
here will tell us. They made tens of thousands of these so it must have
had a need...
Usual reason would be to drive several small speakers or to do so over a
long run - like 100v line. Where a matching transformer is situated with
the speaker.

--
*I believe five out of four people have trouble with fractions. *

Dave Plowman dave@davenoise.co.uk London SW
To e-mail, change noise into sound.
 
I'll see you on the third half of the show
"Dave Plowman (News)" <dave@davenoise.co.uk> wrote in message
news:4ffc1861a9dave@davenoise.co.uk...
In article <NzXRk.7853$YU2.4393@nlpi066.nbdc.sbc.com>,
Henry Kolesnik <kolesnik@nojunksbcglobal.net> wrote:
I was wrong it's only 10 watts. I know of no reason, perhaps someone
here will tell us. They made tens of thousands of these so it must
have
had a need...

Usual reason would be to drive several small speakers or to do so over
a
long run - like 100v line. Where a matching transformer is situated
with
the speaker.

--
*I believe five out of four people have trouble with fractions. *

Dave Plowman dave@davenoise.co.uk London SW
To e-mail, change noise into sound.
 

Welcome to EDABoard.com

Sponsor

Back
Top