L
lpfm2k4
Guest
Hi there,
I'll hope i'am in the correct n.g. here.
Serious, i've got some sort of a problem; someone dropped me an
Ultiboard v5.72 .ddf file and a .sch schematic file.
I would like to make the pcb-board from these files, but i'am
absolutely *not* familiar with the program itself. What i would like
is to print the layout (with a DeskJet 890C printer) on a transparent
sheet, those 3M-things.
With these sheets i can process them myself.
My question; can someone help me to verify (check if you will) this
..ddf file?
(I'am not sure if it's 100% correct...)
What i have is this:
- a .ddf file in UltiBoard v5.72 format
- a .sch file in UltiCap v5.72 format
- 600dpi bitmap scans of the original layout (both layers).
Any help is very much appreciated!
Hope to hear.
Kind regards,
Hans
e-mail: rf_design(AT)hotmail(DOT)com
I'll hope i'am in the correct n.g. here.
Serious, i've got some sort of a problem; someone dropped me an
Ultiboard v5.72 .ddf file and a .sch schematic file.
I would like to make the pcb-board from these files, but i'am
absolutely *not* familiar with the program itself. What i would like
is to print the layout (with a DeskJet 890C printer) on a transparent
sheet, those 3M-things.
With these sheets i can process them myself.
My question; can someone help me to verify (check if you will) this
..ddf file?
(I'am not sure if it's 100% correct...)
What i have is this:
- a .ddf file in UltiBoard v5.72 format
- a .sch file in UltiCap v5.72 format
- 600dpi bitmap scans of the original layout (both layers).
Any help is very much appreciated!
Hope to hear.
Kind regards,
Hans
e-mail: rf_design(AT)hotmail(DOT)com