Thermal Relief in Protel

[Brendon]

Hi All,

I want to have a pad on the board with no thermal relief, connected to a
plane. How do I do this in Protel 99 SE? Is there an option somewhere?



Thanks,
Brendon

 

[Brad Velander]

Brendon,
First you must be sure if it is a plane or a poured polygon,
there are two different rules. Under DRC rules ("D", "R") go to
the second tab ("Manufacturing") and find the appropriate
connection rule for either Power Plane Connection Style or
Polygon Connect style. Write a rule for your pad that you want
directly connected and set the connection type to "Direct
Connect".
You could write the rule for your PAD using the Footprint/Pad
specification or you could make a Pad class that contains that
pad and write the rule using the pad class.
--
Sincerely,
Brad Velander

"Brendon" <someone@microsoft.com> wrote in message
news:430942b5$1@clear.net.nz...

Hi All,

I want to have a pad on the board with no thermal relief,
connected to a
plane. How do I do this in Protel 99 SE? Is there an option
somewhere?



Thanks,
Brendon

 

Brendon,
you'll have to create a new design rule under plane connects.
Select the net and change the thermal relief type to direct connect.
I am not sure if this will affect the whole net or if you can select one via
or pin and change the scope of the rule.
Carl


"Brendon" <someone@microsoft.com> wrote in message
news:430942b5$1@clear.net.nz...

Hi All,

I want to have a pad on the board with no thermal relief, connected to a
plane. How do I do this in Protel 99 SE? Is there an option somewhere?



Thanks,
Brendon