Tek 7613

[JKoning]

After sitting unused for quite a while, the traces of my Tek 7613 scope are
skewed.
AFAICS this is not a front panel adjustment, unless I'm blind. And, sorry,
no manual :-(
Anybody know where to find the "trace-rotation/trace-alignment" pot?

Thanks,
Jan.

 

[Bob]

JKoning wrote:

After sitting unused for quite a while, the traces of my Tek 7613
scope are skewed.
AFAICS this is not a front panel adjustment, unless I'm blind. And,
sorry, no manual :-(
Anybody know where to find the "trace-rotation/trace-alignment" pot?

Thanks,
Jan.

It's been a long time since I worked on Tek scopes - if it's not on the
front panel, then it might have been located on the storage board; that
would be the large circuit board on the right side of the scope, next to the
CRT. Pop the covers and snoop around; as I recall, it was a two wire
connector (black and red wires) that went to the trace rotation coil.

Hope this helps,
Bob.

 

[Andy Cuffe]

On Fri, 16 Apr 2004 11:57:45 +0200, "JKoning" <jkoning@sealandnet.nl>
wrote:

After sitting unused for quite a while, the traces of my Tek 7613 scope are
skewed.
AFAICS this is not a front panel adjustment, unless I'm blind. And, sorry,
no manual :-(
Anybody know where to find the "trace-rotation/trace-alignment" pot?

Thanks,
Jan.

My 7623 has the rotation adjustment located on top of the scope. It
was the only top access hole on the scope. These is definitely a
rotation adjustment somewhere.
Andy Cuffe
baltimora@psu.edu

 

[Jim Yanik]

"JKoning" <jkoning@sealandnet.nl> wrote in
news:407fae65$0$27301$fb624cd1@morenews.zeelandnet.nl:

After sitting unused for quite a while, the traces of my Tek 7613
scope are skewed.
AFAICS this is not a front panel adjustment, unless I'm blind. And,
sorry, no manual :-(
Anybody know where to find the "trace-rotation/trace-alignment" pot?

Thanks,
Jan.

On the right rear side of the scope,on the top,is a narrow PCB,that is the
Z-axis amp and related CRT (geom,astig,T-rot)adjustments.IIRC,the pot you
want is labelled.

--
Jim Yanik
jyanik-at-kua.net

 

[JKoning]

I have found the trace rotation pot on the Z-axis board.
Possibly the 7613 found it's successor in the 7623 because of the difficult
access of the relevant pot.
There's no cover hole to access T-rot.
But, it is labeled indeed... , P1170... like all the pot's on the Z-axis
board are numbered.

Anyway, traces are fine now, flat like the Dutch horizon

Thanks everybody for helping out!

Rgds,
Jan.