Strange error in Quartus II 3.0

[Panic]

After searching for the source of an error for quite a long time, I've
decided that I need some help, and once again you guys drew the shortest
straw ;-)

I have a 8 bit DFF with output q[7..0]. This feeds the net
dff_inst23_out[7..0]. (The reason this net is given this name, was to see if
the error actually was located where I thought it was, since the original
error pointed to some temp net.) Both the DFF output and the net is 8 bits
wide, and still I get this error message:

Error: Net dff_inst23_out[6] cannot be assigned more than one value
Error: Net is fed by std_8bit_dff0:inst8|lpm_ff:lpm_ff_component|dffs[6]
Error: Net is fed by std_8bit_dff0:inst9|lpm_ff:lpm_ff_component|dffs[6]
Error: Net is fed by std_8bit_dff0:inst23|lpm_ff:lpm_ff_component|dffs[6]

This is repeated for each bit of dff_inst23_out.

Ok, so I have two other registers that feed this net, but they are not
connected! I understand that this is happening because the output of these
other registers are the same as the inst23 one, but hey, I've got more
registers like that, all over the place! So why is this happening to this
particular net?

I've taken a screenshot of the design in question, and my troublesome net is
the blue stub:
http://www.battlefield.no/bilder/inst23.gif

Any suggestions would be appreaciated!
Sincerely
-"Panic"

 

[Panic]

Ooops. Should have been posted in comp.arch.fpga....

Sorry.

 

[Marc Guardiani]

Make sure you don't have another net with the same name. Even if they
are not physically connected, they will be logically connected.

Panic wrote:

Error: Net dff_inst23_out[6] cannot be assigned more than one value
Error: Net is fed by std_8bit_dff0:inst8|lpm_ff:lpm_ff_component|dffs[6]
Error: Net is fed by std_8bit_dff0:inst9|lpm_ff:lpm_ff_component|dffs[6]
Error: Net is fed by std_8bit_dff0:inst23|lpm_ff:lpm_ff_component|dffs[6]

This is repeated for each bit of dff_inst23_out.