A
Anjan
Guest
Hi
I am designing a board using spartan3 1.5million device. I got few
questions
1. I am planning to configure the device using a host DSP. The
interface is 3.3 V and slave serial mode. I am connecting a series
resistor between the DSP dicrete & PROGB of FPGA to make it tolerant
and so for CCLK and DIN. I am pulling DONE INIT to 3.3 V for the same
reason. Am I correct i this?
2. Please suggest suitable decoupling for the power supply.
Rgd
Anjan
I am designing a board using spartan3 1.5million device. I got few
questions
1. I am planning to configure the device using a host DSP. The
interface is 3.3 V and slave serial mode. I am connecting a series
resistor between the DSP dicrete & PROGB of FPGA to make it tolerant
and so for CCLK and DIN. I am pulling DONE INIT to 3.3 V for the same
reason. Am I correct i this?
2. Please suggest suitable decoupling for the power supply.
Rgd
Anjan