Small P clips - not exactly electronic

[nospam]

I am designing a small PCB (about 15 x 60mm) which will have an M3 mounting
hole each end. I need to fasten a cable (probably 3-4mm diameter) to the
board and a small P clip under one of the mounting screws seems like a good
plan.

I have some p-clips in my junk box which are about the right size, about
14mm long and 6.5mm wide and would take a 5mm cable. The only marking on
them is "NXI".

I can't seem to find a source for anything this small. They all seem to be
9.5mm wide and even the ones taking a 3.2mm cable are about 18mm long.

Can anyone point me at a supplier or catalogue with a good range of small
p-clips?

 

[Spehro Pefhany]

On Sun, 08 Aug 2010 21:11:56 +0100, the renowned nospam
<nospam@please.invalid> wrote:

I am designing a small PCB (about 15 x 60mm) which will have an M3 mounting
hole each end. I need to fasten a cable (probably 3-4mm diameter) to the
board and a small P clip under one of the mounting screws seems like a good
plan.

I have some p-clips in my junk box which are about the right size, about
14mm long and 6.5mm wide and would take a 5mm cable. The only marking on
them is "NXI".

I can't seem to find a source for anything this small. They all seem to be
9.5mm wide and even the ones taking a 3.2mm cable are about 18mm long.

Can anyone point me at a supplier or catalogue with a good range of small
p-clips?

http://www.mouser.com/catalog/specsheets/EPD-200464.pdf




Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
speff@interlog.com Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com

 

[nospam]

Spehro Pefhany <speffSNIP@interlogDOTyou.knowwhat> wrote:

Can anyone point me at a supplier or catalogue with a good range of small
p-clips?

http://www.mouser.com/catalog/specsheets/EPD-200464.pdf

Thanks, smaller than anything I found. Maybe I should be searching for
cable clamps.