A
Abdelmajid
Guest
Hello,
I built my design with EDK (using BSB base system builder),
I generated my xparameters.h
I compiled U-boot (the bootloader)
I generate an ace file. ($ xmd genace.tcl -jprog -board ml300 -hw
implementation/download.bit -elf u-boot -ace top.ace, I used:
genace.tcl given by xilinx in a reference design)
When running u-boot on the ML300 board, I have nothing on
Hyperterminal???
I don't understand where is the problem (it is not a problem of a
baudrate, and I have tested my design in standalone and it is OK)
Thanks
Abdelmajid
I built my design with EDK (using BSB base system builder),
I generated my xparameters.h
I compiled U-boot (the bootloader)
I generate an ace file. ($ xmd genace.tcl -jprog -board ml300 -hw
implementation/download.bit -elf u-boot -ace top.ace, I used:
genace.tcl given by xilinx in a reference design)
When running u-boot on the ML300 board, I have nothing on
Hyperterminal???
I don't understand where is the problem (it is not a problem of a
baudrate, and I have tested my design in standalone and it is OK)
Thanks
Abdelmajid