Reusing code (Altera Quartus II 3.0)

[Panic]

Hi

I am a relative "n00b" with regard to FPGA-programming,
but I'm currently working on a Rijndael-implementation on
a APEX1A dev.board. And I have run into some problems.

I want to put my top-level design together from several smaller
building blocks, that I want to design, compile, simulate and
"forget". So when I need them later on, I'd like to simply import
them into my design.

The only way I have managed to do this so far, is to copy the design-
files from their original location, and into my new project directory.
And this clearly isn't very efficient or simple.

I know there has to be a simpler and better way, but I haven't benn
able to figure it out yet. So all suggestions would be greatly appreaciated.

-"Panic"

 

[Subroto Datta]

There are several approaches based on different levels of complexity.

The simplest one
1. Create each block as a Quartus project in its own directory.
2. Create a symbol for each block. Use the File Create/Update Symbol Files
for Current File command. This command also creates Entity/module
definitions that can be referred to in other HDL files.
3. Next create a project called "top" where you can stitch all these
different symbols together into a single schematic (bdf file), using the
Quartus Block editor. Another alternative is to stitch them together using a
Verilog or VHDL file.
4. To compile this "top" project you will need to Create User Library
Entries that points to each of the directories that contain the separate
blocks. This is needed so that the source files of each of these blocks can
be found during netlist extraction and synthesis (quartus_map), at the start
of the compile. The User Libraries setting can be found from the
Assignment->Settings->Files and Directories->User Libraries dialog.

One word of caution: This approach requires that you do not have
entities/modules with the same name in different User Library Directories.
If you do have entities/modules with the same name in different directories
the extractor will find and use the first reference only which is not what
you want.

5. Next add the root level VHDL and Verilog Files for each block to the
"top" project. This is done from the Assignment->Settings->Files and
Directories->Add/Remove command. This is not needed if you have followed the
convention that each entity/module is in a HDL file with the same name.

6. Compile the "top" level project. If the software says that files cannot
be found this means you have missed something in steps 4 and 5.

- Subroto Datta
Altera Corp.


"Panic" <panic74@hotmail.com> wrote in message
news:2PEfb.28070$os2.390826@news2.e.nsc.no...

Hi

I am a relative "n00b" with regard to FPGA-programming,
but I'm currently working on a Rijndael-implementation on
a APEX1A dev.board. And I have run into some problems.

I want to put my top-level design together from several smaller
building blocks, that I want to design, compile, simulate and
"forget". So when I need them later on, I'd like to simply import
them into my design.

The only way I have managed to do this so far, is to copy the design-
files from their original location, and into my new project directory.
And this clearly isn't very efficient or simple.

I know there has to be a simpler and better way, but I haven't benn
able to figure it out yet. So all suggestions would be greatly
appreaciated.

-"Panic"

 

[Panic]

Thank you so very much, Subroto Datta. I had partly managed
to figure out how to do it, but you put the final pieces in their
places. So thank you once again.

It is such a luxury to be able to get expert help, from such a broad
variety of skilled engineers that frequent this news group.

Respect to all of you

-"Panic"