Resister help needed

[mike urig]

I want to reduce the voltage from 1.5 volts to 1.0 - .90 volts.
What resister would do this and what end goes toward to 1.5 volt side?
Thanks

 

[John Fields]

On Sat, 29 Dec 2007 12:49:01 GMT, mike urig <murig@verizon.net>
wrote:

I want to reduce the voltage from 1.5 volts to 1.0 - .90 volts.
What resister would do this and what end goes toward to 1.5 volt side?
Thanks

---
That's not enough information. What are you trying to do?


--
JF

 

[mike urig]

On Sat, 29 Dec 2007 08:58:57 -0600, John Fields wrote:

On Sat, 29 Dec 2007 12:49:01 GMT, mike urig <murig@verizon.net> wrote:

I want to reduce the voltage from 1.5 volts to 1.0 - .90 volts. What
resister would do this and what end goes toward to 1.5 volt side? Thanks

---
That's not enough information. What are you trying to do?

The voltage drop will tell an onboard motorcycle computer to richen the
fuel ratio a little more than stock. The signal comes from an O2 sensor
in the exhaust header pipes. I'm just trying to reduce the voltage a
little more than stock.

You can go here: http://www.nightrider.com/parts/
hd2007HD_nbo2_voltage_divide.htm and read the part about "Testing the
NBO2 Inline Enrichment Device off the bike".

 

[mike urig]

On Sat, 29 Dec 2007 12:49:01 +0000, mike urig wrote:

I want to reduce the voltage from 1.5 volts to 1.0 - .90 volts. What
resister would do this and what end goes toward to 1.5 volt side? Thanks

Never mind, I found the schematic.