N
N_Cook
Guest
Assuming a direct replacement is unobtanium. There is no standard for the
rotating mechanism and at leaast 3 headforms: normal , half width R/P plus
E, half width R/P. But there seems to be a standard of the heads, all I've
checked are set in 15mm Al cylinder with 11mm centres fixing holes. Anyone
ever swapped these integral with head ? if required to actually swap heads ,
what is the best way to unglue/unbond the resin/glue seating them in the Al,
heat? Maybe different front/rear-axis length. At least reseating replacement
head is not as critical as VCR head placement. Azimuth setting screw seems
to be the endstop for the rotating mechanism.
rotating mechanism and at leaast 3 headforms: normal , half width R/P plus
E, half width R/P. But there seems to be a standard of the heads, all I've
checked are set in 15mm Al cylinder with 11mm centres fixing holes. Anyone
ever swapped these integral with head ? if required to actually swap heads ,
what is the best way to unglue/unbond the resin/glue seating them in the Al,
heat? Maybe different front/rear-axis length. At least reseating replacement
head is not as critical as VCR head placement. Azimuth setting screw seems
to be the endstop for the rotating mechanism.