J
JSreeniv
Guest
Hi,
I was exploring the DUT connectivity with my testbench(TB). What i am
doing: With my encrypted DUT i wrote a TB (for reception) MIL 1553 FE
by configuring the register to the mode as RT and start sending the
command and number of data on 1553_rx lines (where the command and
data are Valid) w.r.t the standard and after some response time the
transmitter will send a status word followed by data word on 1553_tx
lines.
The actual query is that can i configure one DUT as BC mode and again
same DUT as RT mode (Here we can change DUT names while configuring in
ModelSim) so that my TB can handle the communication between BC and RT
mode.
Since i have only RT terminal register set i can access whatever i
want, but i don't have register set for BC but mode setting facility
is available for the register.
Could anyone suggest me whether this is possible or not and some more
analysis.
Thanks
Nivas.
I was exploring the DUT connectivity with my testbench(TB). What i am
doing: With my encrypted DUT i wrote a TB (for reception) MIL 1553 FE
by configuring the register to the mode as RT and start sending the
command and number of data on 1553_rx lines (where the command and
data are Valid) w.r.t the standard and after some response time the
transmitter will send a status word followed by data word on 1553_tx
lines.
The actual query is that can i configure one DUT as BC mode and again
same DUT as RT mode (Here we can change DUT names while configuring in
ModelSim) so that my TB can handle the communication between BC and RT
mode.
Since i have only RT terminal register set i can access whatever i
want, but i don't have register set for BC but mode setting facility
is available for the register.
Could anyone suggest me whether this is possible or not and some more
analysis.
Thanks
Nivas.