RCA P60928 PTK195 Chassis no power

[Tmachcinsk@aol.com]

I had a power surge that killed my TV and microwave. PTK 195 chassis.
I get no picture no sound no attempt to power on. No clicking.
Nothing. Main fuse is ok power is ok just past the fuse. Any ideas.
Thanks Ted

 

On Fri, 1 Oct 2010 07:55:40 -0700 (PDT), "Tmachcinsk@aol.com"
<Tmachcinsk@aol.com> wrote:

I had a power surge that killed my TV and microwave. PTK 195 chassis.
I get no picture no sound no attempt to power on. No clicking.
Nothing. Main fuse is ok power is ok just past the fuse. Any ideas.
Thanks Ted
Several.

1. I was not aware anyone had sold a combination TV and microwave.
2. Giving the chassis number properly assists in searching. (it is the
PTK195 chassis, not the PTK 195).
3. The Photofact album is available at http://elektrotanya.com

PlainBill

 

[John-Del]

On Oct 1, 10:55 am, "Tmachci...@aol.com" <Tmachci...@aol.com> wrote:

I had a power surge that killed my TV and microwave. PTK 195 chassis.
I get no picture no sound no attempt to power on. No clicking.
Nothing. Main fuse is ok power is ok just past the fuse. Any ideas.
Thanks Ted

The 195 is not a modular chassis, it is expected that anyone who
attempts repair can troubleshoot to the component level, and deal with
surface mounted devices. That said, the 195 is extraordinarily
reliable, earlier versions needing a flyback perhaps, but a long lived
and excellent performing analog TV.

Start by checking for 5 volts at the IR receiver on top of the light
box. If that's there, you have a system control problem, maybe the
micro reset circuit, corrupted eeprom, etc. If no 5v exists, the main
smps is out. Watch out, this supply holds a vicious charge for a long
time.

 

[Meat Plow]

On Fri, 01 Oct 2010 07:55:40 -0700, Tmachcinsk@aol.com wrote:

I had a power surge that killed my TV and microwave. PTK 195 chassis. I
get no picture no sound no attempt to power on. No clicking. Nothing.
Main fuse is ok power is ok just past the fuse. Any ideas. Thanks Ted

My ideas depend on your experience in electronics repairs.



--
Live Fast, Die Young and Leave a Pretty Corpse

 

[Tmachcinsk@aol.com]

Thanks John. I have no problem going to component level. I do a lot of
work on arcade game monitors. I have not realy worked on projections.
I do not know where some of the components are located on the
projection. You are correct about the flyback as I have replaced that
years ago otherwise no other problems with the tv. Thanks that gives
me a good starting point. Ted

 

[Tmachcinsk@aol.com]

OK looks like the 5 volts is good. Where is the micro reset circut
located. Thanks Ted

 

[Meat Plow]

On Sat, 02 Oct 2010 05:52:08 -0700, Tmachcinsk@aol.com wrote:

OK looks like the 5 volts is good. Where is the micro reset circut
located. Thanks Ted

The micro/eeprom reset is a service function.



--
Live Fast, Die Young and Leave a Pretty Corpse

 

[Tmachcinsk@aol.com]

ok so how do I get into service mode if I cant power on the set. Is
there a service switch on the pcb somewhere. Thanks Ted

 

[Meat Plow]

On Sat, 02 Oct 2010 12:16:08 -0700, Tmachcinsk@aol.com wrote:

ok so how do I get into service mode if I cant power on the set. Is
there a service switch on the pcb somewhere. Thanks Ted

Hey, have you tried to get some service literature on the 195 chassis?
Might want to wait around for PlainBill to chime back in. He works on a
lot more of these than I. I switched my service genre to vintage guitar
amps and other pro sound/studio equipment a while back.

You've already replaced a flyback in this thing so obviously you know
something about them. My experience is limited to convergence amps, a
common failure in some sets. But in my youth I worked for a multi-brand
warranty center and was always handed the tough dog sets.



--
Live Fast, Die Young and Leave a Pretty Corpse

 

[John-Del]

On Oct 2, 8:52 am, "Tmachci...@aol.com" <Tmachci...@aol.com> wrote:

OK looks like the 5 volts is good. Where is the micro reset circut
located. Thanks Ted

You said there is no power on attempt (no clicking ). The 195 is very
quiet when attempting a start as it has no relays. In a quiet room,
start the TV from the remote listening carefully in the back of the
TV. If you hear anything (chirp), the system control is okay, at
least the basic stuff. If it's truly dead, check the micro reset
voltage: On the main micro U13101, check pin 51 for 5 volts.

 

[Tmachcinsk@aol.com]

OK I have 5 volts on pin 51. I know its very quite but I dont hear
anything at all. Are you thinking U13101 may be bad? Thanks Ted

 

[Tmachcinsk@aol.com]

OK I have even put an amp meter on the line comming in and I am
getting around 300 milli amps when pluged in but no change at all when
I hit the remote. I get a slight chirp when I first plug it in but no
change again with the remote. Thanks Ted

 

[John-Del]

On Oct 2, 7:05 pm, "Tmachci...@aol.com" <Tmachci...@aol.com> wrote:

OK I have even put an amp meter on the line comming in and  I am
getting around 300 milli amps when pluged in but no change at all when
I hit the remote. I get a slight chirp when I first plug it in but no
change again with the remote. Thanks Ted

It's unlikely the micro is bad unless you caught some lightning. Of
the two, the eeprom is more likely to have failed, but are uncommon in
the 195. If the eeprom is bad, you will need to confirm it with a
scope. If the Vcc and reset voltages are good at the micro, but
there is no response from the system control, there are a couple of
possibilities. The easy one is to unplug the front panel connector
from the top of the light box where the IR is located. If the TV
powers up from the remote, you've got bad tact switches on the front
control board. You can either leave it unplugged, or replace all the
tacts. If it doesn't respond, get a bright light and look for any
evidence of coolant leakage around the micro, eeprom, and LV
regulators. If you have coolant leakage in any area, it will need to
be removed (time consuming).

 

On Sat, 2 Oct 2010 20:00:08 +0000 (UTC), Meat Plow <mhywatt@yahoo.com>
wrote:

On Sat, 02 Oct 2010 12:16:08 -0700, Tmachcinsk@aol.com wrote:

ok so how do I get into service mode if I cant power on the set. Is
there a service switch on the pcb somewhere. Thanks Ted

Hey, have you tried to get some service literature on the 195 chassis?
Might want to wait around for PlainBill to chime back in. He works on a
lot more of these than I. I switched my service genre to vintage guitar
amps and other pro sound/studio equipment a while back.

You've already replaced a flyback in this thing so obviously you know
something about them. My experience is limited to convergence amps, a
common failure in some sets. But in my youth I worked for a multi-brand
warranty center and was always handed the tough dog sets.
Too late. I already referred him to elektrotanya, which has the

Photofact folder. It's free. If the doofus isn't smart enough to
read it, there is no way I''m going to encourage him to stick his
hands into the chassis.

http://elektrotanya.com/?q=showresult&megnev=rca&megnev2=PTK195&kategoria=&kat2=all

PlainBill

 

[Tmachcinsk@aol.com]

OK John Thank you very much. Last question. Where can I get a new set
of switches. I never would have thought it would have been that easy.
Thanks again. Ted

 

[Tmachcinsk@aol.com]

Thanks for nothing plainbill. I never stated it was a combo microwave
tv. I stated both went so that you would know it was probably a
problem from an electric surge being that two thing went at the same
time. I did give the chassis number and the model of the tv I cant
help it if you cant read. The link you sent me was not in english and
would not convert to english so that was useless. Whos the doofus now.
Thanks everyone else for your help. Ted

 

[Meat Plow]

On Sun, 03 Oct 2010 10:17:26 -0700, Tmachcinsk@aol.com wrote:

Thanks for nothing plainbill. I never stated it was a combo microwave
tv. I stated both went so that you would know it was probably a problem
from an electric surge being that two thing went at the same time. I did
give the chassis number and the model of the tv I cant help it if you
cant read. The link you sent me was not in english and would not convert
to english so that was useless. Whos the doofus now. Thanks everyone
else for your help. Ted

The PDF manuals are scans in english. You can dowload 2 a day if not a
signed up member.
This is probably what you want:
RCA PHOTOFACT GOLD P52939YX1 CHASSIS PTK195S1B S1

select it then select Get Manual.



--
Live Fast, Die Young and Leave a Pretty Corpse

 

[PeterD]

On Sun, 3 Oct 2010 09:23:47 -0700 (PDT), "Tmachcinsk@aol.com"
<Tmachcinsk@aol.com> wrote:

OK John Thank you very much. Last question. Where can I get a new set
of switches. I never would have thought it would have been that easy.
Thanks again. Ted

Did we miss something? He suggested a test, and you are saying you
want to replace switches... So you tested and the switch module was
bad?

 

[Tmachcinsk@aol.com]

John suggested pulling the wires from the ir board that go to the
front panel on/off chnl swithches and see if the remote would turn on
the tv. That fixed it. One of the switches on the front panel must be
stuck on. Ted

 

[Michael A. Terrell]

"Tmachcinsk@aol.com" wrote:

John suggested pulling the wires from the ir board that go to the
front panel on/off chnl swithches and see if the remote would turn on
the tv. That fixed it. One of the switches on the front panel must be
stuck on. Ted

Then pull out the panel and test the switches. There aren't that
many different types of tactical switches. All you need to do is match
the footprint & height in most cases. There are a lot of places to buy
new ones, or if you're a cheapskate you can probably find on in an old
computer mouse or junk VCR/ DVD player that will fit.

<http://parts.digikey.com/1/parts-kws/tactile-switch>

<http://www.mouser.com/Search/ProductDetail.aspx?R=101-0164-EVvirtualkey12040000virtualkey101-0164-EV>

<http://www.mcmelectronics.com/product/28-10735&CAWELAID=220320974>

Each of these companies carry different styles.


--
Politicians should only get paid if the budget is balanced, and there is
enough left over to pay them.