M
Mike
Guest
Hi,
I'm new to Synopsys Design Compiler. I have some questions:
1. Should I always set drive strength and load driven by the ports before
optmization? But I don't know what kind of value i can use and how to get
the value? for drive strength and load?
2. Should I always set input_delay and output_delay? In the tutorial manual
of Synopsys Design Compilefr, it only
set output delay to the Clock? Why don't we need to set
input_delay?
3. After I compiled my design, and I found slack time
for all end-points are zero? Is this correct?
Thanks.
Liang
I'm new to Synopsys Design Compiler. I have some questions:
1. Should I always set drive strength and load driven by the ports before
optmization? But I don't know what kind of value i can use and how to get
the value? for drive strength and load?
2. Should I always set input_delay and output_delay? In the tutorial manual
of Synopsys Design Compilefr, it only
set output delay to the Clock? Why don't we need to set
input_delay?
3. After I compiled my design, and I found slack time
for all end-points are zero? Is this correct?
Thanks.
Liang