Protel DXP question

[scd]

Hi,

Is there a way to make Protel re-sequence all of the component references on
a schematic?
For example, if I want to duplicate a schematic page that has component
references
U1 to U10, I want the components on the duplicated page to be automatically
re-sequenced to U11 to U20. Is there a way to do this?

Thanks,
Scott

 

[Brad Velander]

Scott,
With all the variables involved in this procedure, it is not
simply nor consistently accomplished with Protel. Yes if you only
had the two sheets then you could do it pretty reliably. However
Protel does some strange things with annotating multiple sheets
and the sheet order is not readily apparent. Someone figured it
out before I don't recall how the sheet order was accomplished to
readily give them control over the annotation of multiple sheets.
If you are just trying to do this with the ICs, I would just
do it manually. If you are trying it with numbers of variable
components, Good Luck.

--
Sincerely,
Brad Velander

"scd" <scd@nospam.com> wrote in message
news:jXTrc.6616$be.5891@newsread2.news.pas.earthlink.net...

Hi,

Is there a way to make Protel re-sequence all of the component
references on
a schematic?
For example, if I want to duplicate a schematic page that has
component
references
U1 to U10, I want the components on the duplicated page to be
automatically
re-sequenced to U11 to U20. Is there a way to do this?

Thanks,
Scott