Problems Configurating MicroBlaze into RC200 board

[Mois?s]

I have been following several tutorials to build a simple system that
only prints a string by the serial port. My system includes a
Microblaze, Bram Block, UART Lite, and bram controllers for
instructions and data.

When I build the example I don't have problems, I generate libraries,
compile the sources, generate the netlist, generate the bitstream
obtening the file system.bit. Finally I update the bitstream to merge
data and design into the download.bit file.

But when I try to configure into a Virtex 2 (RC200 board
XC2V1000FG456-4) the device never ends the configuration process, it
looks as if something were missing, like the end of file or anything
else.

Somebody has experienced this?
I hope that somebody can help me with this.

Thanks in advance

 

[Tony]

You can try the Parallel Cable III to connect to the JTAG port in
order to config the board

You need to use XPS together with a download script for IMPACT as well
as the relevent bsd file

Hoping that would be useful

 

[Mois?s]

iamtung@sinaman.com (Tony) wrote in message news:<be913553.0311190708.507c2b43@posting.google.com>...

You can try the Parallel Cable III to connect to the JTAG port in
order to config the board

You need to use XPS together with a download script for IMPACT as well
as the relevent bsd file

Hoping that would be useful

Thanks Tony, I think that the cable isn't the problem, because I have
several examples running in the RC200 board that has been configurated
and work without problems. Obviously I used the program that celoxica
provides to download and configurate the bitstream into the FPGA.

The problem is that the configuration process never ends.

Thanks again.