P
Peter Sjoblom
Guest
Hi
Is there a practical limit in how many different parameter-sweep I can
do in one batch?
When I use fewer than 10 different sweep (each only containig two
points) there is no problem. But when I increase the number of sweeps to
sy 15 (still each sweep has only two different values), I ran into
troubble.
If I try to select only a few of the sweeps and run those, I get the
message "to many points" and "sweep specification is invalid".
If I try to run all, the simulations start, but does not finnish all. A
few runs remains when it says that it doesent have write permission to
/spectre/shematics
Have anyone else have had the same problem?
BR
Peter
--
Peter Sjöblom M.Sc.
Asperation / Perlos
Lund University
Box 118
SE-221 00 Lund
Sweden
Mobile +46 708 405 476
peter.sjoblom@perlos.com
http://www.perlos.com
Is there a practical limit in how many different parameter-sweep I can
do in one batch?
When I use fewer than 10 different sweep (each only containig two
points) there is no problem. But when I increase the number of sweeps to
sy 15 (still each sweep has only two different values), I ran into
troubble.
If I try to select only a few of the sweeps and run those, I get the
message "to many points" and "sweep specification is invalid".
If I try to run all, the simulations start, but does not finnish all. A
few runs remains when it says that it doesent have write permission to
/spectre/shematics
Have anyone else have had the same problem?
BR
Peter
--
Peter Sjöblom M.Sc.
Asperation / Perlos
Lund University
Box 118
SE-221 00 Lund
Sweden
Mobile +46 708 405 476
peter.sjoblom@perlos.com
http://www.perlos.com