Pool chlorinator, Pool Store International, Q Diamond 1200

[Franc Zabkar]

I have a salt water chlorinator, model Q-Diamond 1200, manufactured by
Pool Store International. It has a faulty controller module which I
haven't been able to remove from the front panel. It appears to
consist of two halves, one on each side of the front panel. There are
no screws, just eight dimples in the plastic fascia (4 at the front, 4
at the rear) which suggest some kind of tamper proof snap lock
fasteners may be used. I've decided to drill these out, but before I
do so, does anyone have any experience with these units?

BTW, I've already contacted the manufacturer, but they were of no help
at all.


- Franc Zabkar
--
Please remove one 's' from my address when replying by email.

 

[Franc Zabkar]

On Sun, 15 Aug 2004 16:35:40 +1000, Franc Zabkar
<fzabkar@optussnet.com.au> put finger to keyboard and composed:

I have a salt water chlorinator, model Q-Diamond 1200, manufactured by
Pool Store International. It has a faulty controller module which I
haven't been able to remove from the front panel. It appears to
consist of two halves, one on each side of the front panel. There are
no screws, just eight dimples in the plastic fascia (4 at the front, 4
at the rear) which suggest some kind of tamper proof snap lock
fasteners may be used. I've decided to drill these out, but before I
do so, does anyone have any experience with these units?

OK, I drilled out the dimples and the two halves of the controller
separated as expected. Unfortunately the electronics are potted in
epoxy. :-(


- Franc Zabkar
--
Please remove one 's' from my address when replying by email.