B
Bo-Lennart
Guest
Hi....I have an PHILIPS PATTERN GENERATOR, model: PM5515.
There is a problem with the display. Mostly it is dark, but sometime its working. When it's working, I can see that there are 2 segments out of order.
I have looked everywhere for a new one, but I can't find it.
The display is named: SI35035. Is there someone out there that know where I can find a new one (or a used, if its working).
The display is a module, included a 34-bit Shift register/34-bit latches and 34 bit buffer/driver for the four 7-segments LED digit. The data is feed into the module with I2C (SDA and SCL). There is also a pin DISPLAY ENABLE, that open up the SDA-signal to the display.
Service-manual is here:
https://doc.xdevs.com/doc/PHILIPS/PHILIPS%20PM%205518%20Service.pdf
You can find the display at page # 39.
Can someone help me solve this problem?
Best regards from SWEDEN
Bo-Lennart Karlsson
bo-lennart.karlsson@telia.com
There is a problem with the display. Mostly it is dark, but sometime its working. When it's working, I can see that there are 2 segments out of order.
I have looked everywhere for a new one, but I can't find it.
The display is named: SI35035. Is there someone out there that know where I can find a new one (or a used, if its working).
The display is a module, included a 34-bit Shift register/34-bit latches and 34 bit buffer/driver for the four 7-segments LED digit. The data is feed into the module with I2C (SDA and SCL). There is also a pin DISPLAY ENABLE, that open up the SDA-signal to the display.
Service-manual is here:
https://doc.xdevs.com/doc/PHILIPS/PHILIPS%20PM%205518%20Service.pdf
You can find the display at page # 39.
Can someone help me solve this problem?
Best regards from SWEDEN
Bo-Lennart Karlsson
bo-lennart.karlsson@telia.com