D
Darrin
Guest
I am looking for a small-scale PCB maker in and around Sydney for a few
prototype boards? Any help appreciated.
prototype boards? Any help appreciated.
Navigation
Install the app
How to install the app on iOS
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
More options
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
R
Richard Freeman
Guest
"Darrin" <darrin_2000au@yahoo.com> wrote in message
news:409f5e01$1@dnews.tpgi.com.au...
......
Sesame Electronics ( http://members.tripod.com/~sesame_elec/ ) Offer
Prototyping services
This is based on a panel size of 150*250 mm which will cost approx $100 for
this you get the PCb etched and Drilled (appears to be by hand and they
offer cheaper for undrilled boards) they have experimented in the past with
various tinning techniques (unsuccessfully) but now just leave the resist on
the PCB which can be cleaned off with Metho.
I have just received 2 of their 'Fully Featured boards' which are single
sided 150*110 mm these cost me $160 total and include : Drilling, Solder
tinning, Overlay, Solder mask and I have to say they are a superb job.
The prices for these boards in bulk drops quite steeply I asked for an idea
of how much extra boards would have cost (At this stage my order was for
Prototypes and to see what standard these PCBs were up to)
10 extra would cost another $164
20 extra would cost another $255
50 extra would cost another $379
Regards
Richard Freeman
news:409f5e01$1@dnews.tpgi.com.au...
Well I was holding out on replying to this Post until I got some PCBs backI am looking for a small-scale PCB maker in and around Sydney for a few
prototype boards? Any help appreciated.
......
Sesame Electronics ( http://members.tripod.com/~sesame_elec/ ) Offer
Prototyping services
This is based on a panel size of 150*250 mm which will cost approx $100 for
this you get the PCb etched and Drilled (appears to be by hand and they
offer cheaper for undrilled boards) they have experimented in the past with
various tinning techniques (unsuccessfully) but now just leave the resist on
the PCB which can be cleaned off with Metho.
I have just received 2 of their 'Fully Featured boards' which are single
sided 150*110 mm these cost me $160 total and include : Drilling, Solder
tinning, Overlay, Solder mask and I have to say they are a superb job.
The prices for these boards in bulk drops quite steeply I asked for an idea
of how much extra boards would have cost (At this stage my order was for
Prototypes and to see what standard these PCBs were up to)
10 extra would cost another $164
20 extra would cost another $255
50 extra would cost another $379
Regards
Richard Freeman
B
Bob Parker
Guest
Try RCS Radio. http://www.rcsradio.com.au
"Darrin" <darrin_2000au@yahoo.com> wrote:
"Darrin" <darrin_2000au@yahoo.com> wrote:
I am looking for a small-scale PCB maker in and around Sydney for a few
prototype boards? Any help appreciated.