Panasonic NV-HD100 VCR returning to standby. Can't eject.

[John Hennessy]

Hi, I have a Panasonic NV-HD100 video recorder that continually drops
back into standby mode.
The unit is powered by the mains ok but pressing the Power 0/1 button
results in the unit becoming active for a few seconds then powering down
to standby again.
There is a tape loaded currently and the eject button has no effect. The
tape was loaded when the fault occurred.

Any assistance in isolating this fault would be appreciated.

john

 

[Ian]

Probably has a split loading motor coupling. Part no: vdp1384 i think (from
memory).

"John Hennessy" <john@hennessy.net.au> wrote in message
news:bm7sa4$c8k$1@yeppa.connect.com.au...

Hi, I have a Panasonic NV-HD100 video recorder that continually drops
back into standby mode.
The unit is powered by the mains ok but pressing the Power 0/1 button
results in the unit becoming active for a few seconds then powering down
to standby again.
There is a tape loaded currently and the eject button has no effect. The
tape was loaded when the fault occurred.

Any assistance in isolating this fault would be appreciated.

john

 

[Loris Duranti]

Sorry: VDP1434 not VDP1384 ...

Good luck. Loris.


Ian <trueblueace@hotmail.com> wrote in message news:3f87b3fe$0$5391$afc38c87@news.optusnet.com.au...

Probably has a split loading motor coupling. Part no: vdp1384 i think (from memory).