OSD strange appearence

[Razor's Edge]

Hi all,

I just would like to send out a strange thing that happened to me yesterday
when I was repairing a Grundig tv-set.
The problem was a normal, routine-job, replacing the high-voltage
transformer and a few components in the E/W circuit.
Everything's back to normal again, set works perfect.
When I turned on the set this morning, I had to decrease the volume and then
I noticed the OSD text-line (VOLUME, bright, etc..) and its meter had been
moved very far to the left, so about only half of the OSD information is
visible on the screen.
I'm certain the OSD was ok right after the repair, caused I adjusted volume,
and color, bright...etc,
I've no idea why this happened, or what caused it, so any advice is
appreciated.

Regards
Stefan

 

[Damir]

It looks like eeprom data are corrupted.
You must enter in service mode and adjust horizontal position of
On Screen Display.

Turn off main switch on TV set.
Press button i on the remote controller and while keep it pressed
turn main switch on .

Regards,
Damir

On Sat, 19 Jul 2003 20:24:29 +0200, "Razor's Edge" <stefan.toftevall@(remove_this)bredband.net>
wrote:

Hi all,

I just would like to send out a strange thing that happened to me yesterday
when I was repairing a Grundig tv-set.
The problem was a normal, routine-job, replacing the high-voltage
transformer and a few components in the E/W circuit.
Everything's back to normal again, set works perfect.
When I turned on the set this morning, I had to decrease the volume and then
I noticed the OSD text-line (VOLUME, bright, etc..) and its meter had been
moved very far to the left, so about only half of the OSD information is
visible on the screen.
I'm certain the OSD was ok right after the repair, caused I adjusted volume,
and color, bright...etc,
I've no idea why this happened, or what caused it, so any advice is
appreciated.

Regards
Stefan