Orcad capture part text

[Active8]

I tried setting my schematic preferences so that text is 10 pt font
and this works for most stuff.

I'd like the text for parts like sources to also have a larger font.
At my screen res, you can barely see that 7 pt font.

What can I do? Anything?

Ok. JT'll hopefully ignore this, but if not, sorry, I still haven't
gotten into PSpice Schematics
--
Best Regards,
Mike

 

[Jim Thompson]

On Wed, 4 Aug 2004 18:56:31 -0400, Active8 <reply2group@ndbbm.net>
wrote:

I tried setting my schematic preferences so that text is 10 pt font
and this works for most stuff.

I'd like the text for parts like sources to also have a larger font.
At my screen res, you can barely see that 7 pt font.

What can I do? Anything?

Ok. JT'll hopefully ignore this, but if not, sorry, I still haven't
gotten into PSpice Schematics

Now WHY would I say anything, Capture is JUST SO INTUITIVE ;-)

...Jim Thompson
--
| James E.Thompson, P.E. | mens |
| Analog Innovations, Inc. | et |
| Analog/Mixed-Signal ASIC's and Discrete Systems | manus |
| Phoenix, Arizona Voice480)460-2350 | |
| E-mail Address at Website Fax480)460-2142 | Brass Rat |
| http://www.analog-innovations.com | 1962 |

I love to cook with wine. Sometimes I even put it in the food.

 

[Boris Mohar]

On Wed, 4 Aug 2004 18:56:31 -0400, Active8 <reply2group@ndbbm.net> wrote:

I tried setting my schematic preferences so that text is 10 pt font
and this works for most stuff.

I'd like the text for parts like sources to also have a larger font.
At my screen res, you can barely see that 7 pt font.

What can I do? Anything?

If you have already drawn the schematic than do the following:

As an example I am assuming that you want to change the font for all part
values for instance.

CTRL-A select all
CTRL-E Mickey Mouse property editor will open
Select Parts tab
Left click on the Value header
Right click and select Display
Change whatever you like in there. If appropriate font size does not show
than type it in.

If you are starting a new design than go to Options, Design Template



Regards,

Boris Mohar

Got Knock? - see:
Viatrack Printed Circuit Designs http://www3.sympatico.ca/borism/

 

[Active8]

On Wed, 04 Aug 2004 20:25:20 -0400, Boris Mohar wrote:

On Wed, 4 Aug 2004 18:56:31 -0400, Active8 <reply2group@ndbbm.net> wrote:


I tried setting my schematic preferences so that text is 10 pt font
and this works for most stuff.

I'd like the text for parts like sources to also have a larger font.
At my screen res, you can barely see that 7 pt font.

What can I do? Anything?


If you have already drawn the schematic than do the following:

As an example I am assuming that you want to change the font for all part
values for instance.

CTRL-A select all
CTRL-E Mickey Mouse property editor will open
Select Parts tab
Left click on the Value header
Right click and select Display
Change whatever you like in there. If appropriate font size does not show
than type it in.

Thanks. That does the job and the shortcuts are much appreciated.

If you are starting a new design than go to Options, Design Template

Ah. Template and dsgn props. Same but different. TNX again.

--
Best Regards,
Mike