R
rekisum
Guest
Hi,
I got an hierarchical design where I added one sheet
multiple times as hierarchical blocks.
This works fine in general.
I arranged the blocks in rows and columns
as I wanted them to appear on the PCB.
But after I run an annotate over the whole design,
Capture (9.2) assigend the part numbers not the way I wanted it to.
I didn't start with the first block in the upper left corner
but somwhere in the middle..
I don't understand the way Capture assignes part references in
hierarchical designs. Anyone does?
And if yes, is there a way to control it?
Regards,
Reksium
I got an hierarchical design where I added one sheet
multiple times as hierarchical blocks.
This works fine in general.
I arranged the blocks in rows and columns
as I wanted them to appear on the PCB.
But after I run an annotate over the whole design,
Capture (9.2) assigend the part numbers not the way I wanted it to.
I didn't start with the first block in the upper left corner
but somwhere in the middle..
I don't understand the way Capture assignes part references in
hierarchical designs. Anyone does?
And if yes, is there a way to control it?
Regards,
Reksium