D
Dziadek
Guest
Hi,
My company uses Orcad line of products: Capture CIS and Layout. For most
designs it is OK, but I wonder how to make RF (gigahertz) design with these
tools (delay lines, distributed components etc.). No problem with
simulation - there are some tools for it. But how to draw in Capture a
schematic that uses components made of copper on PCB? And Layout does not
seem to be intended for "drawing" a coil or similar...
Are there any software products supporting RF design in Orcad? Or maybe a
guide somewhere in the net?
Best regards,
Dziadek
My company uses Orcad line of products: Capture CIS and Layout. For most
designs it is OK, but I wonder how to make RF (gigahertz) design with these
tools (delay lines, distributed components etc.). No problem with
simulation - there are some tools for it. But how to draw in Capture a
schematic that uses components made of copper on PCB? And Layout does not
seem to be intended for "drawing" a coil or similar...
Are there any software products supporting RF design in Orcad? Or maybe a
guide somewhere in the net?
Best regards,
Dziadek