"No PSpiceTemplate for DN1" warning in OrCAD 10.3 after Plac

Folks,
I encountered a show stopping warning after I created a schmatic in
Capture, and attempted to run the simulation using part that wasn't in
the standard capture library. I selected Place->Database Part->Internet
Component Assistant (ICA), with Part Number "Bav99 T/R", then clicked
"Place in Schematic". Using this part I created a circuit, then placed
a "Voltage/Level Marker" at an output point. After I clicked the "Run
PSpice" for the active profile, I received the following warning
message:

View DRC Marker
WARNING: [NET0093]
No PSpiceTemplate for DN1, ignorning

I have two other parts that I used in my schematic that also came from
placing database part, and they produce the same sort of warning
messages. Any suggestions how to resolve this issue?
Thanks
-Bea

 

yes i added a pspicetemplate property, but it looks like part of the
show stopper was that i didn't set "Implementation Type" to PSpice
Model. The warning didn't stop the show, as it was an error in another
area. this tool is very difficult to use...
-bea