M
Mark
Guest
I pulled a board from an epson dot matrix printer, plan to use the
parts to build a pan/tilt mount for a mini dv camera, using an analog
joysick for control.
I think I can get everything I need to do this off this printer.
It has a good stepper motor driver stk6712 but the other motor driver
is marked Japan 5N on the top and below PU1501 , I cant seem to find
the manufacturer or a spec sheet .
Other part is a toshiba microprocessor or microcontroller labeled
TMP90C041F.
I tried the toshiba site but there parts just skip from tmp88 to 91.
Last part number is used to drive the dot matrix pins and they are NEC
PA1476H its using 6 of these control a 24 pin printer so I assume each
controls 4 pins.
I'm trying to do this as a hobby project and one for our church since
we cant afford 400.00 for a commercial mount.
All help appreciated.
Email is correct as is, so you can reply here or email me.
thanks
Mark
parts to build a pan/tilt mount for a mini dv camera, using an analog
joysick for control.
I think I can get everything I need to do this off this printer.
It has a good stepper motor driver stk6712 but the other motor driver
is marked Japan 5N on the top and below PU1501 , I cant seem to find
the manufacturer or a spec sheet .
Other part is a toshiba microprocessor or microcontroller labeled
TMP90C041F.
I tried the toshiba site but there parts just skip from tmp88 to 91.
Last part number is used to drive the dot matrix pins and they are NEC
PA1476H its using 6 of these control a 24 pin printer so I assume each
controls 4 pins.
I'm trying to do this as a hobby project and one for our church since
we cant afford 400.00 for a commercial mount.
All help appreciated.
Email is correct as is, so you can reply here or email me.
thanks
Mark