Multilinx, where do I get 3.3V power?

F

Francis

Guest
I am using MultiLinx to program my XC2V1000 thru JTAG connector.
I got TMS, TCK, TDI, TDO correctly, but unable to find the 3.3V and GND.
Without this 3.3V, I can detect devices on two out of three JTAG ports on my
board, and I need the third port to work.

I am applying a 2.5V on the PWR & GND of the SelectMAP(?) connector on
my Multilinx and it drew 0.9A power. I am unable to find another power
supply
to make 3.3V now. :(

What can I do with this situation?

Thanks
 
My mistake, MultiLINX runs from 2.5V - 5.0V, thus 3.3V solves my problem.



"Francis" <FrancisChee@h0tmail.cxm> wrote in message
news:dkssgd$b2b$1@reader01.singnet.com.sg...
I am using MultiLinx to program my XC2V1000 thru JTAG connector.
I got TMS, TCK, TDI, TDO correctly, but unable to find the 3.3V and GND.
Without this 3.3V, I can detect devices on two out of three JTAG ports on
my
board, and I need the third port to work.

I am applying a 2.5V on the PWR & GND of the SelectMAP(?) connector on
my Multilinx and it drew 0.9A power. I am unable to find another power
supply
to make 3.3V now. :(

What can I do with this situation?

Thanks
Click to expand...
 
You must log in or register to reply here.

Welcome to EDABoard.com

Sponsor

Back
Top