Monitor pinout question

[exray]

My KDS monitor (VS-5) finally kicked the bucket. I have an old, working
(I think) monitor here but the cable has been chopped off and I want
to chop the KDS cable and put it on the old guy.
The old monitor is a DigiView HR-1434, also super VGA and VGA compatible.
Problem is that the KDS cable has two additional wires and the color
codes obviously aren't the same. I know the pin out on the d-shell
connector but need info about the color code on the Digiview cable to
know what the remaining 4 wires are. (Brown, black, yellow, wht).

Any help?

Thanks in advance,

Bill

 

[Sam Goldwasser]

"Bart Bervoets" <nekobe@online.be> writes:

www.hardwarebook.net

That is probably not the entire story. There is no standard for the
wire color coding or internal pinout of monitors. Therefore, splicing
a cable where one end has been cut and the VGA connector is long gone
requires detective work.

See: http://www.repairfaq.org/sam/monfaq.htm#monicucmc

--- sam | Sci.Electronics.Repair FAQ Home Page: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Site Info: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: The email address in this message header may no longer work. To
contact me, please use the feedback form on the S.E.R FAQ Web sites.

 

[exray]

Sam Goldwasser wrote:

That is probably not the entire story. There is no standard for the
wire color coding or internal pinout of monitors. Therefore, splicing
a cable where one end has been cut and the VGA connector is long gone
requires detective work.

Yep. Thats why I'm hoping someone might know this monitor (Digiview
HR-1434) or have the schematic.

Thanks,
Bill