ModelSim problem

C

Cor

Guest
Hi guys,

I have got a very strange problem regarding ModelSim.

Both at the office as at home I use the 6.0c version of ModelSim SE. At
the office everything works like a charm, but when I try to siumulate
the excact same design at home ModelSim dies without any warning or
error message during the load of the design. This happens with every
design I try to load for simulation. Compilation of source code in
ModelSim works perfectly.

I tried everything I could think of to solve this issue, but to no
avail.
- Reinstalled ModelSim
- Downgraded to 5.8
- Upgraded to 6.1
- Reinstalled the FlexLM dongle drivers

Anybody experienced this behaviour before? Any idea about the cause and
how to solve it?


Best regards,

Cor
 
Cor wrote:

I tried everything I could think of to solve this issue, but to no
avail.
- Reinstalled ModelSim
- Downgraded to 5.8
- Upgraded to 6.1
- Reinstalled the FlexLM dongle drivers
Sounds like a memory problem.
Try it at home on a different computer.

-- Mike Treseler
 
Cor wrote:
Hi guys,

I have got a very strange problem regarding ModelSim.

Both at the office as at home I use the 6.0c version of ModelSim SE. At
the office everything works like a charm, but when I try to siumulate
the excact same design at home ModelSim dies without any warning or
error message during the load of the design. This happens with every
design I try to load for simulation. Compilation of source code in
ModelSim works perfectly.

I tried everything I could think of to solve this issue, but to no
avail.
- Reinstalled ModelSim
- Downgraded to 5.8
- Upgraded to 6.1
- Reinstalled the FlexLM dongle drivers

Anybody experienced this behaviour before? Any idea about the cause and
how to solve it?
Is that the one where all the Modelsim windows vanish suddenly?

Try deleting your work library and compiling your code again.

Regards,
Allan
 

Welcome to EDABoard.com

Sponsor

Back
Top