Modelsim MXE on wine?

I had MXE (Modelsim Xilinx Edition) running successfully under Wine
until recently. However, following a lot of changes, I 've just
re-installed it, and can't get vsim running. My setup is SL(/RHEL)6,
64-bit, wine 1.2.3. I've installed MXE-III Starter, for both VHDL and
Verilog. When I run vsim I get a pop-up with a long message which
starts:

'can't read "view_master": no such variable when executing
"GUIMAIN"...'

The problem is in the tcl start-up (tcl/vsim/vsim). Anyone else seen
this? Any ideas?

Thanks.

 

[Allan Herriman]

On Thu, 28 Jun 2012 14:45:54 +0100, nospam wrote:

I had MXE (Modelsim Xilinx Edition) running successfully under Wine
until recently. However, following a lot of changes, I 've just
re-installed it, and can't get vsim running. My setup is SL(/RHEL)6,
64-bit, wine 1.2.3. I've installed MXE-III Starter, for both VHDL and
Verilog. When I run vsim I get a pop-up with a long message which
starts:

'can't read "view_master": no such variable when executing "GUIMAIN"...'

The problem is in the tcl start-up (tcl/vsim/vsim). Anyone else seen
this? Any ideas?

I've seen that same error message with Modelsim under Wine. It was a
year or two ago using 64 bit Ubuntu so I can't remember the exact details
but the problem eventually went away when Canonical included a more
recent version of Wine.

The errors went away with Wine 1.4, however I now use Windows 7 on my
work computer and versions of Modelsim post 6.something work fine on that.

Regards,
Allan
(followups not set)