Mitsubishi Big Screen

I

Ian V

Guest
TO ALTRONICS. I HAVE THIS UNIT CAME IN FOR
CONVERGENCE. THERE ARE THREE ICS ON
RIGHT SIDE OF DEFLECTION BOARD. ALSO
THERE ARE PICA FUSES FOR EACH IC. ALSO
THERE ARE COILS IN FRONT OF EACH IC CHECK
FOR HEAT AND OPEN. ONCE YOU REPLACE ICS
AND PICA FUSE TRY TO ADJUST TEST PATERN TO
VERTICAL AND HORIZONTAL. WHEN FINISHED
PUT GENERATOR IN VIDEO 1. WITH
CROSSHATCH . THEN HIT MENU 2359 ENTER
YOU ARE IN DIGITAL MODE. YOU SHOULD BE
ABLE TO ADJUST .



THANKS IN ADVANCED
 
Well I guess we know it's one of the last few Mits. chassis' with a 4 digit
model number, but which one ?

I'm sorta confused here, is this a tip ? If so why the thanks at the end ?

JURB

P.S. Don't touch the DA values or do a reset when in setup.
 
Ian V[riggers30@hotmail.com] iscrivinhated/wrotou na mensage/messagem
<cAVTb.217$gQ2.150@newsfep1-gui.server.ntli.net> no grupo de newstícias
sci.electronics.repair a exatos Tue, 3 Feb 2004 22:55:20 -0000 :

TO ALTRONICS. I HAVE THIS UNIT CAME IN FOR
CONVERGENCE. THERE ARE THREE ICS ON
RIGHT SIDE OF DEFLECTION BOARD. ALSO
THERE ARE PICA FUSES FOR EACH IC. ALSO
THERE ARE COILS IN FRONT OF EACH IC CHECK
FOR HEAT AND OPEN. ONCE YOU REPLACE ICS
AND PICA FUSE TRY TO ADJUST TEST PATERN TO
VERTICAL AND HORIZONTAL. WHEN FINISHED
PUT GENERATOR IN VIDEO 1. WITH
CROSSHATCH . THEN HIT MENU 2359 ENTER
YOU ARE IN DIGITAL MODE. YOU SHOULD BE
ABLE TO ADJUST .
Click to expand...
Fix your caps lock key first.
Is this understood to be a hint or a request for help?



--
ChaosŽ - posting from Brazil
wizard_of_yendor.666@hotmail.com
remove the number of the beast - 666
 
Hi, sorry... this was a response to an old reqest by altronics....sorry
about the confusion.



"JURB6006" <jurb6006@aol.com> wrote in message
news:20040203184943.19387.00000970@mb-m26.aol.com...
Well I guess we know it's one of the last few Mits. chassis' with a 4
digit
model number, but which one ?

I'm sorta confused here, is this a tip ? If so why the thanks at the end ?

JURB

P.S. Don't touch the DA values or do a reset when in setup.
Click to expand...
 
You must log in or register to reply here.

Welcome to EDABoard.com

Sponsor

Back
Top