mitsubishi and 4507 r convergence problem

[Bob E]

Hey I have the the Misubishi VS4507R projection TV. My nieghbor gave
me the tv it works and all that but I can't aligh the convergence
linesthe blue is way off and the red and green get close. I see the
small trim pots on the circuit board and a trim pot on each tube
circuit board. I don't know what the trim pots on the tube boards are,
but I was wondering if there is a way that I can align fro any pots or
anything. Can the convergence get out by moving the TV from one house
to another

Please help,
Thanks

 

[BWL]

You've most likely got a bad convegence IC; common problem on all projection
sets. Don't mess with the control pots if you're not very sure what you're
doing. Get someone qualified to check it out; repairs are not that expensive
for this problem, and you should get good use out of set.

 

[Art]

Have the tech go thru the complete set and check for bad caps. If you want
to keep this set in opration for a peroid of time.
"BWL" <btvfxer@aol.com> wrote in message
news:20040323125805.29754.00000151@mb-m19.aol.com...

You've most likely got a bad convegence IC; common problem on all
projection
sets. Don't mess with the control pots if you're not very sure what you're
doing. Get someone qualified to check it out; repairs are not that
expensive
for this problem, and you should get good use out of set.