Mits Model # ck3526r Vertical problem

[Video Doctor]

I have a mitsubishi television model # ck3526r and the problem that I have
is the picture is to tall but I am wondering if the original remote is
needed to make any other adjustment on the vert. It is a crt single tube.
Any help on this would be greatly appreciated

chuck

 

[john]

Change the caps in the vertical section that will fix the problem.
kip

--
"Watch the return E-Mail addy its false"
"Video Doctor" <thevideodoctor@earthlink.net> wrote in message
news:Mvhdc.1450$k05.1271@newsread2.news.pas.earthlink.net...

I have a mitsubishi television model # ck3526r and the problem that I have
is the picture is to tall but I am wondering if the original remote is
needed to make any other adjustment on the vert. It is a crt single tube.
Any help on this would be greatly appreciated

chuck

 

[Shoreline Electronics]

The Height and Linearity controls are inside.

Although....you are probably looking at defective Capacitors C4e4 & C4e5 -
100uf. 35v., C4e3 - 1uf. 50v.


This set should be in need of a good cap tune-up if one has not been done on
it.


--
==========================
Jeff Stielau
Shoreline Electronics Repair
344 East Main Street
Clinton,CT 06413
860-399-1861
860-664-3535 (fax)
jstielau@snet.net
========================
"If you push something hard enough it will fall over."
Fudd's First Law of Opposition - Sir Sidney Fudd


"Video Doctor" <thevideodoctor@earthlink.net> wrote in message
news:Mvhdc.1450$k05.1271@newsread2.news.pas.earthlink.net...

I have a mitsubishi television model # ck3526r and the problem that I have
is the picture is to tall but I am wondering if the original remote is
needed to make any other adjustment on the vert. It is a crt single tube.
Any help on this would be greatly appreciated

chuck

 

[BWL]

And don't forget to check the small tantalum; it can cause weird vertical
patterns; you can sub it temporarily with a standard electrolytic of the same
value, but if it needs to be replaced, use another of the same type...