Z
Zach Thomas
Guest
Hello -
I have recently acquired an HP 8510B Network analyzer (with an 8516A
test set, and a 83640A sweep), and would like to use GPIB to connect
it to my PC. I also have some motors to move my DUT / receiver around
to make S21 measurements at various positions.
The procedure I'd like to automate is:
1) Move to receive position "n"
2) Measure and save S21 from 10G to 20G
3) increment "n"
Right now I can do 1,3 easily in matlab, but I can't communicate with
the NA.
I have the Instrument Control Toolbox for Matlab, but don't yet have a
GPIB card. What GPIB card do you recommend, and more importantly what
additional issues do I face. Does the 8510B support the Standard
Commands for Programmable Instruments (SCPI) language? Do I need any
software specific to the 8510B? Any web resources that I should check
out?
Thanks very much,
Zach
I have recently acquired an HP 8510B Network analyzer (with an 8516A
test set, and a 83640A sweep), and would like to use GPIB to connect
it to my PC. I also have some motors to move my DUT / receiver around
to make S21 measurements at various positions.
The procedure I'd like to automate is:
1) Move to receive position "n"
2) Measure and save S21 from 10G to 20G
3) increment "n"
Right now I can do 1,3 easily in matlab, but I can't communicate with
the NA.
I have the Instrument Control Toolbox for Matlab, but don't yet have a
GPIB card. What GPIB card do you recommend, and more importantly what
additional issues do I face. Does the 8510B support the Standard
Commands for Programmable Instruments (SCPI) language? Do I need any
software specific to the 8510B? Any web resources that I should check
out?
Thanks very much,
Zach