KV-M2531U Frame Collapse

[Prosonman]

Hi,

I have a Sony KV-M2531U that has a collapsed frame - single line across
middle of screen.

The vertical delflection circuit is based around a TDA8170 that has been
replaced but it still will not work. Supply voltages seem OK and components
around it read OK. I once had ciruit diagrams but have now lost them so if
anyone has a circuit for the vertical deflection section it would be much
aprreciated or if any ideas what the problem maybe.

What restistance should the vertial coil read, I get a reading of 8.2Ohms.?


Many thanks
Richard

 

[Sofie]

snipped:

"Prosonman" <tech@proson.co.uk> wrote in message
I have a Sony KV-M2531U that has a collapsed frame - single line across
middle of screen.
The vertical delflection circuit is based around a TDA8170 that has been
replaced but it still will not work. Supply voltages seem OK and
components
around it read OK. I once had ciruit diagrams but have now lost them so if
------------------------

Richard:
Is the flyback derived B+ getting to the vertical output stage???
--
Best Regards,
Daniel Sofie
Electronics Supply & Repair
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

 

[Nigel]

The field scan coupling capacitor C531 (680uF, 25v) is the cause of many
field faults with this set.
Sony now supplies a 680uF replacement rated at 50v (105 degree).
Sony part number 1-111-123-11


"Prosonman" <tech@proson.co.uk> wrote in message
news:bg8ao4$bof$1@sparta.btinternet.com...
Hi,

I have a Sony KV-M2531U that has a collapsed frame - single line across
middle of screen.

The vertical delflection circuit is based around a TDA8170 that has been
replaced but it still will not work. Supply voltages seem OK and components
around it read OK. I once had ciruit diagrams but have now lost them so if
anyone has a circuit for the vertical deflection section it would be much
aprreciated or if any ideas what the problem maybe.

What restistance should the vertial coil read, I get a reading of 8.2Ohms.?


Many thanks
Richard

 

[Prosonman]

"Prosonman" <tech@proson.co.uk> wrote in message
news:bg8ao4$bof$1@sparta.btinternet.com...

Hi,

I have a Sony KV-M2531U that has a collapsed frame - single line across
middle of screen.

The vertical delflection circuit is based around a TDA8170 that has been
replaced but it still will not work. Supply voltages seem OK and
components
around it read OK. I once had ciruit diagrams but have now lost them so if
anyone has a circuit for the vertical deflection section it would be much
aprreciated or if any ideas what the problem maybe.

What restistance should the vertial coil read, I get a reading of
8.2Ohms.?


Many thanks
Richard

Thanks for info, tried suggested problems but still no luck. However I have
discovered a broken track that may have caused TDA8170 to fail ( Pin 6 and 7
short circuit on IC). Will try another new TDA8170 tomorrow when it arrives.

Thanks again.
Richard