L
LM
Guest
I use the MachXO2-1200ZE Breakout Board. I noticed that independent
programmers for the FPGA (LCMXO2-1200ZE) are expensive.
Is it possible to bridge wires from the Demo board to an external
board to program chip on that board. Instructions? Where is this
mentioned in the documentation. The schematic diagram is quite
unclear.
programmers for the FPGA (LCMXO2-1200ZE) are expensive.
Is it possible to bridge wires from the Demo board to an external
board to program chip on that board. Instructions? Where is this
mentioned in the documentation. The schematic diagram is quite
unclear.