How to read and modify the file .bin of 80C51????

[Donato Pace]

I have a file .bin of 80c51 and i want modify some parts of it but i
don't know what editor i must use to read this file.

There is a good editor ?????
Please help me.

 

[Spehro Pefhany]

On Fri, 17 Sep 2004 09:33:35 +0200, the renowned "Donato Pace"
<donatopace@infinito.it> wrote:

I have a file .bin of 80c51 and i want modify some parts of it but i
don't know what editor i must use to read this file.

There is a good editor ?????
Please help me.

To modify a bin file directly you can use Ultraedit in hex mode.

http://www.ultraedit.com 30 day or something like that trial, about
EUR 28 to register.

Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
speff@interlog.com Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com

 

[Mickey]

Mozes koristiti i HEX editor.

 

[Ken Smith]

In article <5tilk0th0480968af0dl9r496g86ev74ta@4ax.com>,
Spehro Pefhany <speffSNIP@interlogDOTyou.knowwhat> wrote:

On Fri, 17 Sep 2004 09:33:35 +0200, the renowned "Donato Pace"
donatopace@infinito.it> wrote:

I have a file .bin of 80c51 and i want modify some parts of it but i
don't know what editor i must use to read this file.

There is a good editor ?????
Please help me.

To modify a bin file directly you can use Ultraedit in hex mode.

If it is an Intel OMF file, there can be trouble if you change stuff in
it.

It is often better to load the file into the buffer of whatever prom
programmer you use and edit it there and then write it back out.
--
--
kensmith@rahul.net forging knowledge