How to do DC Operating Point w/ Autitrax?

[EN]

I'm was looking at using PSpice and OrcadLite, doing simple

2 resistor, 1 volt source and 1 node gnd, DC Operating Point

and decided to try using Autotrax 3.12, since I bought it.



I placed the 3 parts down: battery, 2 resistors.

I clicked on the part's end point and stretched the node to the

next part's end point. Ok, this is wrong. Delete all of these lines.

Try using the 'ADD WIRE' icon, way top right, 4th icon.

Now there are not so many errors. But still not right, can't do

DC Opertaing Point.



.... (begin)...

Note: can't find init file.

Circuit: DC Operating Point

Warning: no nodes given: .plot all

Warning: singular matrix: check nodes 3 and 3

Note: starting Gmin stepping

Note: One successful Gmin step

Note: One successful Gmin step

Note: One successful Gmin step

Note: One successful Gmin step

Note: One successful Gmin step

Note: One successful Gmin step

Note: One successful Gmin step

Note: One successful Gmin step

Note: One successful Gmin step

Note: One successful Gmin step

Note: One successful Gmin step

Warning: singular matrix: check nodes 3 and 3

Warning: Gmin stepping failed

Note: starting source stepping

Warning: singular matrix: check nodes 3 and 3

Warning: source stepping failed

doAnalyses: Matrix is singular

run simulation(s) aborted

Hello Circuit: DC Operating Point

Date: Wed Apr 27 06:37:39 2005





Operating point information:

Node Voltage

---- -------

V(4) ?

V(3) ?

V(1) ?

Source Current

------ -------

v&p#branch ?

Error: .plot: no all analysis found.

elapsed time since last call: 0.000 seconds.

Total elapsed time: 0.000 seconds.

Current dynamic memory usage = 0,

Dynamic memory limit = 0.

....(eof)...



Any help?

thanks