N
no_one
Guest
I agree that the OP seems to have a difficult time with english grammar.
However the question is likely to do with the ability of a spread spectrum
signal (such as GPS) to be properly decoded in what appear to be
disastrously low C/N environments. This might be construed as
"amplification". I suggest he google CDMA and spread spectrum for more
insight.
<kmaryan@gmail.com> wrote in message
news:1118165387.551953.156560@f14g2000cwb.googlegroups.com...
However the question is likely to do with the ability of a spread spectrum
signal (such as GPS) to be properly decoded in what appear to be
disastrously low C/N environments. This might be construed as
"amplification". I suggest he google CDMA and spread spectrum for more
insight.
<kmaryan@gmail.com> wrote in message
news:1118165387.551953.156560@f14g2000cwb.googlegroups.com...
In an attempt not to discourage you from future postings on
sci.electronics.design or other newsgroups, I offer the following tips:
- Don't post your question in the message title. It's rude and will
usually be ignored.
- Try to provide as much detail as possible in your question. Vague
questions get vague answers.
- Be sure to use the correct terminology in your question.
- Mind your grammar.
To answer your question: information theory has almost nothing to do
with amplifying a GPS signal. So I suspect you aren't using the
terminology you intended to use. I assume you meant one of the
following:
A: How does information theory apply to a GPS signal?
B: How do you amplify a GPS signal.
If your question is A, I can offer very little. Information theory
deals mainly with the limits and methods of communicating digital
information. As far as I know, GPS is a digital transmission that is
not especially limited by bandwidth or noise, accordingly, there is
probably relatively little that information theory has to say about a
GPS signal.
If your question is B, I offer the following information. Ask yourself
why you are amplifying it? Then find a suitable amplifier to get from a
1.5GHz GPS signal to whatever output you desire.
These are vague answers, but it was a vague question. Next time please
be more specific or else people may not be willing to help out.
Chris