J
JaBrIoL
Guest
ALL,
Good morning, I am building a calibration set-point device for the
Hioki 3551.
To those who are familiar with batteries, the Hioki 3551 is a battery
hiTester. That not only check your volatge. but also the internal
resistance.
Does some one has an Idea, of how I would build a Battery simulator to
use a calibration set-point device?
So far I came up with putting a load onto a 12vdc supply And I get a
good voltage reading but not a good resistance read.
It bounces around too much.
The way resistance is measured is via 1kz.. thru a wave detection
circuit.
By the way I know there is a Hioki 3551 calibration manual out there.
Does anyone have it?
If you live in the USA or it territories..
you can drop me a voice mail
1-800-699-2466
mailbox 5110121961
note to arjw:
I work for a living.. why can't you do that...???
Good morning, I am building a calibration set-point device for the
Hioki 3551.
To those who are familiar with batteries, the Hioki 3551 is a battery
hiTester. That not only check your volatge. but also the internal
resistance.
Does some one has an Idea, of how I would build a Battery simulator to
use a calibration set-point device?
So far I came up with putting a load onto a 12vdc supply And I get a
good voltage reading but not a good resistance read.
It bounces around too much.
The way resistance is measured is via 1kz.. thru a wave detection
circuit.
By the way I know there is a Hioki 3551 calibration manual out there.
Does anyone have it?
If you live in the USA or it territories..
you can drop me a voice mail
1-800-699-2466
mailbox 5110121961
note to arjw:
I work for a living.. why can't you do that...???
